Using aerosol type from Copernicus Atmosphere in MAJA

=> The main difficulty of the atmospheric correction comes from the determination of the aerosols optical properties: one has to know the optical properties of the aerosol type present in the atmosphere and determine their optical thickness. Using Sentinel-2 data to determine the aerosol type is very complicated, and our MAJA processor, used to generate Theia L2A products, only computes the aerosol optical thickness, while assuming a specific aerosol type. The current operational version of the MAJA processor uses a constant aerosol type during the atmospheric correction, independently from the location and from the time of the year, thus affecting the quality of the atmospheric correction if the chosen aerosol type is not appropriate. As an alternative, we tried to use the information from CAMS (Copernicus Atmosphere Monitoring Service), whichprovides forecasts of the Aerosol Optical Thickness (AOT, see figure below) of five different aerosol types: dust, black carbon, sea salt, sulfate and organic matter. 

The contribution of each one of these aerosols in the atmospheric correction performed by MAJA is then proportional to their AOT. Thanks to this new configuration, the aerosol type used in the atmospheric correction is variable both in time and space (and depends on the CAMS AOT forecasts), and is no longer a parameter to be defined in advance.Time series of Sentinel-2A data are used to perform the atmospheric correction over a selection of arid and vegetated sites, providing a wide range of surface and aerosol conditions. One method to assess the performances of MAJA when using CAMS information is to compare the AOT at 550 nm estimated by MAJA to the ground-based observations from AERONET. The stable cases, in blue, correspond to AERONET observations which are stable with time and with no more than 10% of clouds (according to MAJA cloud mask) within a 10-km neighborhood around the AERONET site. We focus on these cases when estimating the performances. Over arid sites on the figure below, using CAMS information (right) allows a significant improvement of the AOT estimated by MAJA (RMSE=0.068), compared to the constant aerosol method (left, RMSE=0.095). This is especially true over Saada (Morocco) with the RMSE reduced from 0.206 to 0.068, or over Banizoumbou (Niger) with the RMSE reduced from 0.464 to 0.256.

 Over vegetated sites on the figure below, using CAMS information (right) shows a slight increase of the RMSE compared to the constant aerosol method (left), but the performances are of the same order of magnitude. This slight increase can be explained by the fact that the constant aerosol is a standard continental aerosol type, designed to perform better over vegetated sites, and by the noise due to passing from a constant aerosol to a variable one. 

 

Initially, the objective was to avoid selecting a particular method or aerosol type according to the site being processed. Introducing CAMS information allows a variable aerosol type and is a suitable choice to significantly increase the performances over arid sites, and to keep almost the same performances over vegetated sites. More details about this study can be found in the article “Using Copernicus Atmosphere Monitoring Service Products to Constrain the Aerosol Type in the Atmospheric Correction Processor MAJA” published in Remote Sensing and available here.

Plus d'actualités

Dates de fauche en France

En 2024, des collègues du Cesbio ont publié un article* sur la cartographie de la date de fauche en France en 2022 à partir des données satellitaires Sentinel-2.   Leur magnifique figure 10 a attiré mon attention. La version à haute résolution fournie avec l’article (2861 × 2911 pixels) correspond à une image dont les pixels font […]

Évolution du jour de déneigement dans les Alpes françaises et les Pyrénées

Les socio-écosystèmes des Alpes et des Pyrénées dépendent étroitement des fluctuations annuelles du manteau neigeux. En particulier, le moment de l’année où la neige disparait détermine le début de la saison de croissance de la végétation de montagne et donc la période des estives. Le changement climatique est en train de bouleverser ce rythme saisonnier. […]

BIOMASS, the third launched satellite mission designed at CESBIO !

After SMOS in 2009, and VENµS in 2017, the CESBIO laboratory is very proud to see its third proposed mission, Biomass, reach orbit. As always, it has been a long journey from the idea, at the beginning of the century, to the selection in 2013 as the seventh Earth Explorer Mission by ESA, to the […]

Rechercher