THEIA : A new French Data Centre dedicated to Land Surfaces

(French Version)

The THEIA Land Data Centre is a French inter-agency initiative designed to promote the use of satellite data, primarily for environmental research on land surfaces but also for public policy monitoring and for management of environmental resources. Its objective is to foster the use of remote sensing data to measure the impact of human pressure and climate on ecosystems and local areas, to observe, quantify and model water and carbon cycles, to follow the evolution of societies and of their activities, including agricultural practices, and to understand the dynamics of biodiversity.

 

Within the Land Data Centre, CNES set up a production centre named MUSCATE. This centre aims are providing users with ready-to-use products derived from time series of images acquired over large areas. Sentinel-2 will of course be the spearhead of the production centre, but before the launch of the Sentinel-2, MUSCATE will already begin to produce data from the SPOT4 (Take 5) experiment. At the same time, the processing centre also prepares the production of all Landsat data acquired over mainland France from 2009 to 2011.

 

MUSCATE production centre already exists in the form of a prototype developed by CNES with strong support from Cap Gemini. This prototype is already able to handle LANDSAT, SPOT, FORMOSAT-2, Sentinel-2 and Venμs data, using processors developed by CNES for geometric processing [1], and developed by CESBIO for cloud detection [2] and for atmospheric correction [3]. Simultaneously, the development of an operational production facility is being specified.

Products provided by the MUSCATE Centre are:

Simulations of SPOT4(Take5) products from Formosat-2 data
  • Level 1C (orthorectified reflectance at the top of the atmosphere)
  • Level 2A (ortho-rectified surface reflectance after atmospheric correction, along with a mask of clouds and their shadows, as well as a mask of water and snow).
  • Level 3A (bi-monthly or monthly composite products of surface reflectances, obtained as the weighted average surface reflectance of non-cloudy pixels obtained during the period). Up to now, Level 3A chain is only available for Venμs satellite.

The data produced by MUSCATE will be freely distributed to research laboratories on the one hand, and to the French public institutions on the other, they will be if possible distributed freely to a wider community. The Land Data Center is also building a distribution server to make all these data available.

 

Further reading about these products :

[1]: Baillarin, S., P. Gigord, et O. Hagolle. 2008. « Automatic Registration of Optical Images, a Stake for Future Missions: Application to Ortho-Rectification, Time Series and Mosaic Products ». In Geoscience and Remote Sensing Symposium, 2008, 2:II‑1112‑II‑1115. doi:10.1109/IGARSS.2008.4779194.

[2]: Hagolle, Olivier, Mireille Huc, David Villa Pascual, et Gérard Dedieu. 2010. « A multi-temporal method for cloud detection, applied to FORMOSAT-2, VENµS, LANDSAT and SENTINEL-2 images ». Remote Sensing of Environment 114 (8) (août 16): 1747‑1755. doi:10.1016/j.rse.2010.03.002.

[3]: Hagolle, O, G Dedieu, B Mougenot, V Debaecker, B Duchemin, et A Meygret. 2008. « Correction of aerosol effects on multi-temporal images acquired with constant viewing angles: Application to Formosat-2 images ». REMOTE SENSING OF ENVIRONMENT 112 (4) (avril 15): 1689‑1701. doi:10.1016/j.rse.2007.08.016.

 

Plus d'actualités

BIOMASS, the third launched satellite mission designed at CESBIO !

After SMOS in 2009, and VENµS in 2017, the CESBIO Laboratory is very proud to see its third proposed mission, Biomass, reach orbit. As always, it has been a long journey from the idea, at the beginning of the century, to the selection in 2013 as the seventh Earth Explorer Mission by ESA, to the […]

Biophysical parameter retrieval from Sentinel-2 images using physics-driven deep learning for PROSAIL inversion

The results presented here are based on published work: Y. Zérah, S. Valero, and J. Inglada. « Physics-constrained deep learning for biophysical parameter retrieval from sentinel-2 images: Inversion of the prosail model« , in Remote Sensing of Environment, doi: 10.1016/j.rse.2024.114309. This work is part of the PhD of Yoël Zérah, supervised by Jordi Inglada and Silvia Valero. […]

Copernicus should keep S2A operational after S2C launch

The launch of Sentinel-2C (S2C) is scheduled on the 4th of September 2024, next week ! After 3 months of commissioning phase, S2C will replace S2A, to fulfill the Sentinel-2 mission together with S2B. S2B will later be replaced by S2D. The current plans are to keep S2A as a redundant satellite, in case something […]

Rechercher